Page 1431 of 1529

Re: what have you done to your "bike" today

Posted: Tue May 10, 2022 8:17 pm
by sirch345
TaxiDriver wrote: Tue May 10, 2022 6:24 pm
sirch345 wrote: Mon May 09, 2022 7:58 pm
TaxiDriver wrote: Sun May 08, 2022 6:41 pm Knocked up a carbon reservoir bracket for the Brembo MCS master cylinder....

Image

Able to use original lines thanks to this nifty Hel adapter..........
Image
Nice neat job with the carbon fibre bracket :clap:

What's the verdict on the Brembo master cylinder :?:

Chris.
Don't know yet Chris, only just fitted it and new pads going in so after bleed up its on the the rear linkage and the likes.
Might even fit a rear thumb brake,not decided yet,full write up when ready....
No problem, I look forward to hearing from you once the work has been done and you've had time to bed the pads in and get a feel of the new mods :thumbup:

Thanks for your reply,

Chris.

Re: what have you done to your "bike" today

Posted: Tue May 10, 2022 8:38 pm
by fabiostar
Pulled the big girls clutch plates out and replaced them :eek2 . and done the oil and filter again but this time with motul oil . back to what i know works :thumbup:

Re: what have you done to your "bike" today

Posted: Wed May 11, 2022 2:06 pm
by MacV2
Retest on Nue Red. Just stuck me bigger plate on. Job done.

All good for another year.
NueRed MOT 110522.jpg
It's started raing here now so the bits I was gonna do are being put off till tomorrow or Friday whatever.... :lol:

Re: what have you done to your "bike" today

Posted: Wed May 11, 2022 4:39 pm
by tony.mon
MacV2 wrote: Wed May 11, 2022 2:06 pm Retest on Nue Red. Just stuck me bigger plate on. Job done.

All good for another year.

NueRed MOT 110522.jpg

It's started raing here now so the bits I was gonna do are being put off till tomorrow or Friday whatever.... :lol:
You can velcro it over the small one for MOT's. No-one expects the big ones to stay on for long, once you get your ticket.
Stick the red reflector on the big one as well, and you can't forget that come MOT time.

Re: what have you done to your "bike" today

Posted: Wed May 11, 2022 7:59 pm
by sirch345
fabiostar wrote: Tue May 10, 2022 8:38 pm Pulled the big girls clutch plates out and replaced them :eek2 . and done the oil and filter again but this time with motul oil . back to what i know works :thumbup:
That was quick :thumbup:

Chris.

Re: what have you done to your "bike" today

Posted: Wed May 11, 2022 8:01 pm
by sirch345
MacV2 wrote: Wed May 11, 2022 2:06 pm Retest on Nue Red. Just stuck me bigger plate on. Job done.

All good for another year.

NueRed MOT 110522.jpg

It's started raing here now so the bits I was gonna do are being put off till tomorrow or Friday whatever.... :lol:
Always good to get the mot out of the way for another year :thumbup:

How are you finding the OEM clip-on handlebars on Nue Red compared to the Renthal handlebar conversion Mac :?:

Chris.

Re: what have you done to your "bike" today

Posted: Wed May 11, 2022 8:07 pm
by fabiostar
sirch345 wrote: Wed May 11, 2022 7:59 pm
fabiostar wrote: Tue May 10, 2022 8:38 pm Pulled the big girls clutch plates out and replaced them :eek2 . and done the oil and filter again but this time with motul oil . back to what i know works :thumbup:
That was quick :thumbup:

Chris.
had to be quick, its NW200 week so wana get a scoot up :clap: :clap:

Re: what have you done to your "bike" today

Posted: Wed May 11, 2022 8:11 pm
by sirch345
fabiostar wrote: Wed May 11, 2022 8:07 pm
sirch345 wrote: Wed May 11, 2022 7:59 pm
fabiostar wrote: Tue May 10, 2022 8:38 pm Pulled the big girls clutch plates out and replaced them :eek2 . and done the oil and filter again but this time with motul oil . back to what i know works :thumbup:
That was quick :thumbup:

Chris.
had to be quick, its NW200 week so wana get a scoot up :clap: :clap:
Ah, that makes sense :thumbup:

Chris.

Re: what have you done to your "bike" today

Posted: Thu May 12, 2022 7:54 am
by MacV2
sirch345 wrote: Wed May 11, 2022 8:01 pm
MacV2 wrote: Wed May 11, 2022 2:06 pm Retest on Nue Red. Just stuck me bigger plate on. Job done.

All good for another year.

NueRed MOT 110522.jpg

It's started raing here now so the bits I was gonna do are being put off till tomorrow or Friday whatever.... :lol:
Always good to get the mot out of the way for another year :thumbup:

How are you finding the OEM clip-on handlebars on Nue Red compared to the Renthal handlebar conversion Mac :?:

Chris.
Still not 100% convinced on the flat bars TBH the only big difference I get from swapping between the two is your more up in the wind on the flat bars...

Spoilt for choice I guess ! If I was only riding the flat bar version it would be differnt...

I'm on a longer run next week sometime TBA see how it goes.

Re: what have you done to your "bike" today

Posted: Thu May 12, 2022 12:50 pm
by MacV2
Few bits on Nue Red, put the smaller plate back on, did a bit of wire tidying on the left hand front indi whilst the fairing was off to put the LED H/L back in post MOT. :lol: :lol:

Pulled the pads from the front calliper to try & get the number off them to order some more... SBS 566HS apparently...

Re: what have you done to your "bike" today

Posted: Thu May 12, 2022 4:05 pm
by ItsaKeeper
Ordered a reflector to stick on the numberplate in prep for MOT next week, thanks to reading this thread :thumbup:

Re: what have you done to your "bike" today

Posted: Thu May 12, 2022 8:45 pm
by sirch345
MacV2 wrote: Thu May 12, 2022 7:54 am
sirch345 wrote: Wed May 11, 2022 8:01 pm
MacV2 wrote: Wed May 11, 2022 2:06 pm Retest on Nue Red. Just stuck me bigger plate on. Job done.

All good for another year.

NueRed MOT 110522.jpg

It's started raing here now so the bits I was gonna do are being put off till tomorrow or Friday whatever.... :lol:
Always good to get the mot out of the way for another year :thumbup:

How are you finding the OEM clip-on handlebars on Nue Red compared to the Renthal handlebar conversion Mac :?:

Chris.
Still not 100% convinced on the flat bars TBH the only big difference I get from swapping between the two is your more up in the wind on the flat bars...

Spoilt for choice I guess ! If I was only riding the flat bar version it would be differnt...

I'm on a longer run next week sometime TBA see how it goes.
Good to hear your views Mac :thumbup:

It'll be interesting to see if you stick with the Renthal flat bar conversion, or swap them back to the OEM clip-ons. Or in your case keep both :D

Chris.

Re: what have you done to your "bike" today

Posted: Thu May 12, 2022 10:09 pm
by MacV2
sirch345 wrote: Thu May 12, 2022 8:45 pm
MacV2 wrote: Thu May 12, 2022 7:54 am
sirch345 wrote: Wed May 11, 2022 8:01 pm

Always good to get the mot out of the way for another year :thumbup:

How are you finding the OEM clip-on handlebars on Nue Red compared to the Renthal handlebar conversion Mac :?:

Chris.
Still not 100% convinced on the flat bars TBH the only big difference I get from swapping between the two is your more up in the wind on the flat bars...

Spoilt for choice I guess ! If I was only riding the flat bar version it would be differnt...

I'm on a longer run next week sometime TBA see how it goes.
Good to hear your views Mac :thumbup:

It'll be interesting to see if you stick with the Renthal flat bar conversion, or swap them back to the OEM clip-ons. Or in your case keep both :D

Chris.
Most likley... :lol: :lol:

Re: what have you done to your "bike" today

Posted: Fri May 13, 2022 8:59 pm
by sirch345
MacV2 wrote: Thu May 12, 2022 10:09 pm
sirch345 wrote: Thu May 12, 2022 8:45 pm
MacV2 wrote: Thu May 12, 2022 7:54 am

Still not 100% convinced on the flat bars TBH the only big difference I get from swapping between the two is your more up in the wind on the flat bars...

Spoilt for choice I guess ! If I was only riding the flat bar version it would be differnt...

I'm on a longer run next week sometime TBA see how it goes.
Good to hear your views Mac :thumbup:

It'll be interesting to see if you stick with the Renthal flat bar conversion, or swap them back to the OEM clip-ons. Or in your case keep both :D

Chris.
Most likley... :lol: :lol:
:clap: :lol:

Chris.

Re: what have you done to your "bike" today

Posted: Sat May 14, 2022 8:56 am
by rollingthunderx2
Nothing arrived so far.
I have 8 and 7 mm studs here .