VTR1000.ORG

mine was left hand side also, very easy once the fairing is off. I cleaned the lot whilst i was in there and its as new again now.
I must say mine is a 05 bike with low miles and the sh1t that was in there was unbelievable, don't know how it would be on high mileage or older bikes.
Any one know of alternative oil cooler pipes ? Mine resemble coral, totally f****d

Any one know of alternative oil cooler pipes ? Mine resemble coral, totally f****d

Just get some 000 wire wool and a bit of Autosol and they will be like new.

Did you replace the bulb with a standard bulb or fit LED's?

(:-})

Mine are bad too.

Would like LED's for the clocks and front little light. Do you know what 'socket' they are?

t10 i think
http://www.ebay.co.uk/itm/10-x-CAR-SIDE ... 19d5bdadd0

lloydiecbr wrote:Nitron shocks are a good buy at £350 sprung to your weight :-)
Linear springs are best front and back .
I used mct suspension for my front springsand found them very helpful but someone on here had a bad time with them .
7.5w oil in the forks .

That was me! Bloke told me they wouldn't sell springs. Went to K-tech - v good.

BigVeeGrin wrote:

lloydiecbr wrote:Nitron shocks are a good buy at £350 sprung to your weight :-)
Linear springs are best front and back .
I used mct suspension for my front springsand found them very helpful but someone on here had a bad time with them .
7.5w oil in the forks .

That was me! Bloke told me they wouldn't sell springs. Went to K-tech - v good.

k-tech come very highly rated on most forums

Fitted my new to me viper cans......went for a ride.....smiled.....took out the baffles......rode some more.....bigger smile.......went home......started planning how much to cut em down to stubbies,turns out I may be addicted to bigger noise, anyone ever taken apart or cut down viper cans, not sure what to expect when I drill those rivets out? Not sure how I lived with standard cans for nearly a year?

Sent from my GT-I9100 using Tapatalk 2

leave the cans off and go for a ride

Finally got some more clear indi's and popped them on. Been down the local airfield this morning a took a couple of photo's. They do a brill bacon sausage and egg sarnie in the cafe so it had to be done.

Looking good.

I'll have to try that cafe next time I'm over that way. I usually use Dinky's Dinah - lovely gammon sandwich

Gave it a wash and polish...the black one got a quick pledge over to, for her lucky new owner , whoever that may be !!

clean looking bikes there lee....
today i fixed a small oil leak. i also did a little bit of polishing and painted my led mirrors a nice glossy black...

bigspanishmarty wrote:clean looking bikes there lee....
today i fixed a small oil leak. i also did a little bit of polishing and painted my led mirrors a nice glossy black...

Why was it leaking after all ?? Guessing it was a bit lose ??
Oh, and cheers

Renthal bars and bar clamps arrived today, now I can start to work out how I am going to machine the yoke to fit them and still clear the forks where they stick up through the yokes.

Lee why have you got 2 storms?

AMCQ46 wrote:Renthal bars and bar clamps arrived today, now I can start to work out how I am going to machine the yoke to fit them and still clear the forks where they stick up through the yokes.

Lee why have you got 2 storms?

The black one's for sale so I wont have for long !!