Page 1 of 2
how mechanically minded are you.......
Posted: Fri Oct 19, 2007 3:41 pm
by VeetyR
I got 72%....now wheres my lump hammer, i have a stud that needs removing
check it out and post ya results
http://www.forddoctorsdts.com/quizzes/M ... titude.php
Posted: Fri Oct 19, 2007 4:38 pm
by grinner
Bugger, 72% as well! Didn't know nost of the terms used though! (no excuse there)
Timbo- pull my finger- see which way my pulley goes round!
Posted: Fri Oct 19, 2007 5:28 pm
by newbie2
FAILED 80%
Posted: Fri Oct 19, 2007 6:08 pm
by Stratman
Got bored by Q7!
Posted: Fri Oct 19, 2007 6:32 pm
by VTRgirl
68%
Don't tell my mechanical engineering lecturer Dad...
The Shame... The Shame!
Posted: Fri Oct 19, 2007 7:28 pm
by Jaglifter
88% - couple of the questions aren't very clear....
Posted: Fri Oct 19, 2007 8:31 pm
by Beamish
Did 17 questions then realised there was 50...........too much rouge vin for 50,will try again sober
Posted: Sat Oct 20, 2007 12:07 am
by Wicky
Passed 80%
Wonder if that means 20% of the time I tinker on the bike it'll implode on me
Posted: Sat Oct 20, 2007 8:46 am
by newbie2
Wicky wrote:Passed 80%
Wonder if that means 20% of the time I tinker on the bike it'll implode on me
i failed with 80%
Posted: Sat Oct 20, 2007 4:47 pm
by LotusSevenMan
84% so passed but not very happy as I should be better than that!!!
Would like to actually see what I got wrong!!!!!!!
Posted: Sat Oct 20, 2007 6:16 pm
by Jaglifter
One of the electrical symbols - the one that looks like an A/C generator- I've never seen before. Perhaps its an American test!?
Timbo, shooting yourself with a valve collett probably means you shouldn't be a mechanic!!
Posted: Sat Oct 20, 2007 10:10 pm
by RedStormV
Wierd, I passed with 80% 400 points
Says Passing score is 400 points so just scraped a pass.
Posted: Sun Oct 21, 2007 2:17 pm
by kevg
82% for me...know nothing about electrickery
Posted: Mon Oct 22, 2007 11:28 am
by storminateacup
LotusSevenMan wrote:84% so passed but not very happy as I should be better than that!!!
Would like to actually see what I got wrong!!!!!!!
Click the show/hide icon in the bottom left corner it will show you the list of questions and the ones you got wrong, then click on the wrong answer and it shows the right answer.
Posted: Mon Oct 22, 2007 12:32 pm
by Mad Ax
90% - agree that some of the questions are a little bit vague, some of them I just plain and simple got wrong ;)