rear indicator wiring

agentpineapple · Post by **agentpineapple** » Mon Apr 09, 2012 1:33 pm

i put my new rear indis on yesterday, loads of faffing about because i didn't want to take the undertray off, for obvious reasons, when i went to plug them in, the first one was fine, two sererate holes/connectors next to each other, plugged in worked fine, i think this was the n/s, the when i went to plug the o/s indi wires in, the connecter is slightly different its still two holes +/- but they are very close to each other within the same rubber shroud type thingy, when its all plugged in, i still only get the n/s indi working, the wiring from the indis to the connectors are fine. am i plugging them into the wrong holes. i'll try and take some pics today, what was a five minute job has begun to piss me right off and remind me why i get fed up working on cars/bikes......grrrrrrrr
i'm off to take a chill pill.....

lloydie · Post by **lloydie** » Mon Apr 09, 2012 1:45 pm

The double plug is the earth for both left and right side .
Then you should have one orange for one side and one blue for the other

agentpineapple · Post by **agentpineapple** » Mon Apr 09, 2012 2:21 pm

doh!!!!! i'll give it a go, cheers lloydie.....

agentpineapple · Post by **agentpineapple** » Mon Apr 09, 2012 4:38 pm

sorted thanks lloydie, what a palarva that was......

and it looks like you will be getting the rear light after all if geoff comes up trumps with the bulb holders..... and i've just paypaled your money back aswell

lloydie · Post by **lloydie** » Mon Apr 09, 2012 4:45 pm

bigspanishmarty wrote:sorted thanks lloydie, what a palarva that was......
and it looks like you will be getting the rear light after all if geoff comes up trumps with the bulb holders..... and i've just paypaled your money back aswell

pm sent mate

VTR1000.ORG