Page 1 of 1
Swing arm
Posted: Sat Jun 22, 2013 8:53 am
by thumperslaw
Just need to weld it up and a dash of paint
Re: Swing arm
Posted: Sat Jun 22, 2013 9:00 am
by Kev L
The front brace mount needs a little fettling on the right side to get clearance if I remember correctly.
http://www.vtr1000.org/phpBB3/viewtopic ... ce#p162281
Have a look at the oics of mine and you can see it was cut and plated on the left of this pic.
Re: Swing arm
Posted: Sat Jun 22, 2013 5:25 pm
by 8541Hawk
Re: Swing arm
Posted: Sat Jun 22, 2013 8:30 pm
by agentpineapple
make sure you get the rear caliper mounting bracket, er bracket in the correct place. have you got an early blade caliper bracket?
you'll need one so the rear caliper can clear the brace.
looking good thumper....
Re: Swing arm
Posted: Thu Jul 04, 2013 12:57 pm
by Tweety
Did you fill that in afterwards?
Re: Swing arm
Posted: Thu Jul 04, 2013 4:39 pm
by 8541Hawk
Tweety wrote:8541Hawk wrote:Here are a few more for you.......
Did you fill that in afterwards?
Yes I did. It is hard to tell but in the last pic a filler plate has been added.
Re: Swing arm
Posted: Thu Jul 04, 2013 5:06 pm
by Tweety
Aha... gotcha... ;)
