Page 1 of 1
project underseat and VFR 800 onehand singlearm
Posted: Sat Jun 17, 2006 9:17 pm
by vtrracer69
Hello
For everybody who want to implant an underseat exhaust system and VFR 800 swingarm in a superhawk. I can give you informations and tips about it.
And here is the link on the german site!
http://www.vtr1000.de/forum/showthread.php?t=20397
bye
Martin
SINGLE SIDER
Posted: Sat Jun 17, 2006 11:26 pm
by alan
Already done it mate but thanks anyway i like sp1 rear end seen it before on a different one and have been thinking of doing this to mine.It would be alot more helpful if wasnt in german
Posted: Sun Jun 18, 2006 4:36 am
by gcs
Posted: Sun Jun 18, 2006 12:20 pm
by sirch345
Hi Martin,
Thanks for the link, very nice
Chris.
Posted: Sun Jun 18, 2006 2:51 pm
by vtrracer69
Hello Alan
A few month ago I had this idea, too. Because of the different fitting at the SP-1 frame I decided to take the VFR 800 swingarm, because it was easier.
Vfr swingarm
Posted: Sun Jun 18, 2006 2:54 pm
by alan
Martin
did you have to machine your rear sprocket and hub for the chain to line up on the swingarm?
If you want to pm me or email me we can talk swingarms
Posted: Sun Jun 18, 2006 3:39 pm
by vtrracer69
Alan
I had to move the hub on the left side and for the rear sprocket I made some distances.
Bye
Martin
Posted: Mon Jun 19, 2006 1:10 am
by Hanuman
cheers for the link martin. some good photos on that thread.
underseat
Posted: Sat Jul 01, 2006 6:00 pm
by Anonymous
nice job with the swing arm not to sure about the can set up under the seat though. how hard was it to fit swing arm , any major mods needed to donor bike
