Any suggestions would be welcome, the obvious kinds also.
Cheers guys.
![Image](https://i.postimg.cc/PLB0QFqd/6-FCD3-D57-3-B3-E-4-B60-BBFC-72645-B7-EB082.jpg)
Hi Chris, this is quite a discussed subject.ChrisSwindon wrote: ↑Wed Sep 28, 2022 3:16 pm Me and my bright pissing ideas….got headers off to give a quick cheap refurb to, had one stud left in…did the usual (thread release, heat, and used stud puller) and the frigging things sheared off leaving 3-4mm sticking out.
Any suggestions would be welcome, the obvious kinds also.
Cheers guys.
![]()
You'll fit in well hereChrisSwindon wrote: ↑Thu Sep 29, 2022 1:38 am Hi,
Apologies for adding to an already exhausted topic, have used the search function now so if ever I repeat a topic that has already been answered snap me like the stud I snapped today!!!
Unfortunately haven’t access to a mig welder currently (though in the process of making a good case to get one to the wife) so will try blow torching, spraying thread release, and wiggling a bit more…and if that fails will go the dremel route.
Thanks for everyone’s patience.