My VTR with ABM Comfort Kit

[chippy310]

thanks galaxy
what did you do on the cut edge did you use some touch up paint?

[Gallax]

Mines black plastic on dark blue, i just left it and you cant even tell, I had to get a torch to make sure i hadn't sprayed it. If you get it nice and smooth the light shines off it and you would have to get very close to tell it's not blue. i do have some spray though, there are some threads on here to get it from. I did my belly pan and that looks great.

I was about to go take a picture for you but my camera batteries have died...perhaps later

Thanks

[chippy310]

thanks gallax
a pic would be nice.

[Gallax]

Not the best photo I've taken, but gives you the idea.

[Pointblank]

Very tidy .

[chippy310]

thanks for the pic gallax hope to be doing mine this weekend.

[Gallax]

Good luck with it Chippy, if you take your time it's not too bad at all, and the benefits are massive if the stock bars make your wrists ache.

[Enzo_Skyline]

I`ve just got my kit delivered this morning,the kit doesn`t fill me with fear as regards fitting,but the fairing adjusting does!!!

[bikerpiker]

I`ve just got my kit delivered this morning,the kit doesn`t fill me with fear as regards fitting,but the fairing adjusting does!!!

Honestly mate it's dead easy ,when i done mine i used a bit of masking tape to follow the contours of the fairing, then followed the edge of the tape with my dremell tool ,it'll cut with both a toothed steel disc ,or a normal disc.

[Enzo_Skyline]

I`ve just got my kit delivered this morning,the kit doesn`t fill me with fear as regards fitting,but the fairing adjusting does!!!

Honestly mate it's dead easy ,when i done mine i used a bit of masking tape to follow the contours of the fairing, then followed the edge of the tape with my dremell tool ,it'll cut with both a toothed steel disc ,or a normal disc.

Cool then,but if you hear a scream coming from this area,it`ll be me!!!

[bandsawman]

Love the last pic, very arty farty, excellent choice for the old avatar picture.

I agree

[bandsawman]

I`ve just got my kit delivered this morning,the kit doesn`t fill me with fear as regards fitting,but the fairing adjusting does!!!

Honestly mate it's dead easy ,when i done mine i used a bit of masking tape to follow the contours of the fairing, then followed the edge of the tape with my dremell tool ,it'll cut with both a toothed steel disc ,or a normal disc.

So it's just this bit (marked in yellow) that gets cut off?

[bikerpiker]

Aye ,as near as damn it mate ,just make a nice curve with a bit of tape and follow the edge of the tape

[phild]

Just for info boys,
I used a kit from a firm in Blackburn CNC http://www.topyokes.com .You have to replace the whole of the yoke it doesnt fit on top like some do, but, no need to cut fairing.
It cost about £220 and they included some replacement braided clutch and brake lines, very good customer sevice also.
Phil

[AMCQ46]

That is a good price for all the parts you get and the quality of the CNC top yoke..........I am tempted