Screwd it

chris vtr virgin · Post by **chris vtr virgin** » Sat Feb 04, 2012 4:49 pm

Well i have chewed up the nut at the fly wheel innspection hole.
Been reading on how to remove it, but is there any better ones to use other than the soft standard ones.
Cheers
Chris

Wicky · Post by **Wicky** » Sat Feb 04, 2012 5:02 pm

Nope

http://www.vtr1000.org/phpBB3/viewtopic ... 17&start=0

lloydie · Post by **lloydie** » Sat Feb 04, 2012 5:08 pm

you could buy a nice new one and take it to a good engineers and have lots made out of stainless steel and sell the lot on here

playerone · Post by **playerone** » Sat Feb 04, 2012 5:09 pm

cheers wicky, that saved a bit of searching

knew there was a thread about them somewhere.....gonna be a visit to silvers site for me too then once I get the old one off

Stratman · Post by **Stratman** » Sat Feb 04, 2012 6:05 pm

lloydiecbr wrote:you could buy a nice new one and take it to a good engineers and have lots made out of stainless steel and sell the lot on here

That's a good idea!

Diabolus · Post by **Diabolus** » Sat Feb 04, 2012 10:36 pm

chris vtr virgin wrote:Well i have chewed up the nut at the fly wheel innspection hole.
Been reading on how to remove it, but is there any better ones to use other than the soft standard ones.
Cheers
Chris

Dont get me started about the stuborn inspection cap issue !!!

Diabolus · Post by **Diabolus** » Sat Feb 04, 2012 10:47 pm

http://www.haymouth.co.uk/phpBB3/viewto ... up#p177091

I got a new one from ds and o/ring fitted it with plenty of grease and hand tight

tony.mon · Post by **tony.mon** » Sun Feb 05, 2012 4:51 pm

These work well, but I've never seen any more, after I bought them:

VTR1000.ORG

Screwd it

Screwd it

Re: Screwd it

Re: Screwd it

Re: Screwd it

Re: Screwd it

Re: Screwd it

Re: Screwd it

Re: Screwd it