Paddock Stand Bobbins

[bluestoesonnose]

Does anyone make any retrofit paddock stand bobbins? Just wondering before I get the swinging arm modified to take them.

[whitestorm pete]

Dont think so mate im makeing some alu lugs up to weld on the arm

[bluestoesonnose]

Yeah, I'm going to get something similar made, only and hours work and it'll be easier to use the paddock stand with.

[sirch345]

Some of us including me had drilled and tapped the swingarm to take paddock stand bobbins. Have a look at this link, my post (3rd post down) gives dimensions:-
http://www.vtr1000.org/phpBB3/viewtopic ... 16&start=0

Ebay can supply the bobbins for either fitment, IIRC mine were 8mm fine thread.
It's your choice really which you go for.

Chris.

[bluestoesonnose]

Interesting, I'll look into this...

Many thanks

[tony.mon]

You can also fit front ones, drill and tap the short bolt in the rh side, and make a compression fitting from a universal bar end weight rubber for the lh side, in the hollow spindle end.

[simo]

Some of us including me had drilled and tapped the swingarm to take paddock stand bobbins. Have a look at this link, my post (3rd post down) gives dimensions:-
http://www.vtr1000.org/phpBB3/viewtopic ... 16&start=0

Ebay can supply the bobbins for either fitment, IIRC mine were 8mm fine thread.
It's your choice really which you go for.

Chris.

I used these dimensions used 8mm rivinuts (you use a pop rivet type of gun) . The gun is about £12 and a bag of rivinuts £2or 3. eBay.