Cylinder Head
-
carmanbikes
- Posts: 894
- Joined: Sat Dec 22, 2012 11:09 am
- Location: Wigan
Cylinder Head
Hi All,Anyone know the torque settings for the 2 smaller 6mm head bolts,Thanks Very much for all your help , Lee
-
benny hedges
- Posts: 6110
- Joined: Sun Oct 18, 2009 5:09 pm
- Location: Warrington
Re: Cylinder Head
not off hand, but all the torque settings are in the pdf manual in the workshop section or carlsalter.com
just nip them up with a 3.8 ratchet and you wont go far wrong - very hard to snap with a 3/8 due to the length of the bar.
use medium threadlock on all the bolts / nuts and tighten evenly
just nip them up with a 3.8 ratchet and you wont go far wrong - very hard to snap with a 3/8 due to the length of the bar.
use medium threadlock on all the bolts / nuts and tighten evenly
You do not have to say anything. But it may harm your defence if you do not mention when posting something which you later rely on in quote. Anything you do say may be ripped to sh*t.
-
carmanbikes
- Posts: 894
- Joined: Sat Dec 22, 2012 11:09 am
- Location: Wigan
Re: Cylinder Head
Cheers Bennybenny hedges wrote:not off hand, but all the torque settings are in the pdf manual in the workshop section or carlsalter.com
just nip them up with a 3.8 ratchet and you wont go far wrong - very hard to snap with a 3/8 due to the length of the bar.
use medium threadlock on all the bolts / nuts and tighten evenly