Converting stock cct's to manual?

[diverandy]

Just wondering if there are any instructions for doing this? Have done a search but nothing came up . Any help appreciated. Cheers Andy

[BigVeeGrin]

Head to the Workshop Knowledge Base in this section, at the top of page, there are details on stopper mod and manuals

[diverandy]

Thanks for the info but have already done the stopper mod. I am wanting to convert the stock cct's rather than buying manual ones. I have read about someone doing this but there were no instructions.

[VTRDark]

It's something along the lines of gutting it and using a coach bolt. It would have to have a nut or something welded/glued onto the inside to stop the thread of the bolt from poppig out. Then the locknut on the outside. Or maybe once the main shaft and spring and stuff is taken out, then the top could be tapped for the thread to go through. Don't know how it's done exactly.

(:-})

[AMCQ46]

If you have done the stopper you will be fine, there should be no need to go the manual route as the stock ones could last you years now you have taken out insurance to protect against failure.

If you want to try to make a conversion, talk to Bazza who has perfected the method and will do them for you

[diverandy]

Thanks for the replies I think you are right they will probably last for years now I have done the stopper mod. I was going to get some old stock cct's from somewhere and convert them to manual to have on hand for when the inevitable happens. I will wait and see if Bazza comes along with any advice. Cheers Andy