Swing arm

thumperslaw · Post by **thumperslaw** » Sat Jun 22, 2013 8:53 am

Just need to weld it up and a dash of paint

Kev L · Post by **Kev L** » Sat Jun 22, 2013 9:00 am

The front brace mount needs a little fettling on the right side to get clearance if I remember correctly.
http://www.vtr1000.org/phpBB3/viewtopic ... ce#p162281
Have a look at the oics of mine and you can see it was cut and plated on the left of this pic.

8541Hawk · Post by **8541Hawk** » Sat Jun 22, 2013 5:25 pm

Here are a few more for you.......

agentpineapple · Post by **agentpineapple** » Sat Jun 22, 2013 8:30 pm

make sure you get the rear caliper mounting bracket, er bracket in the correct place. have you got an early blade caliper bracket?
you'll need one so the rear caliper can clear the brace.
looking good thumper....

Tweety · Post by **Tweety** » Thu Jul 04, 2013 12:57 pm

8541Hawk wrote:Here are a few more for you.......

Did you fill that in afterwards?

8541Hawk · Post by **8541Hawk** » Thu Jul 04, 2013 4:39 pm

Tweety wrote:
8541Hawk wrote:Here are a few more for you.......

Did you fill that in afterwards?

Yes I did. It is hard to tell but in the last pic a filler plate has been added.

Tweety · Post by **Tweety** » Thu Jul 04, 2013 5:06 pm

Aha... gotcha... ;)

VTR1000.ORG

Swing arm

Swing arm

Re: Swing arm

Re: Swing arm

Re: Swing arm

Re: Swing arm

Re: Swing arm

Re: Swing arm