Which banjo oil pressure bolt?

[VTRPiG]

Hey guys the rearsets don't have a place to mount the brake light switch. Is there a banjo brake switch that would fit the firestorm that I could use? It would be a lot better and neater than trying to lash something together

http://item.mobileweb.ebay.co.uk/viewit ... 1268263142

Hope that link works it's off my phone

[VTRDark]

That's the wrong thread pitch. Most Honda including the VTR are 1.25mm thread pitch. Brembo use 1.0mm.

Here this may be of help.
http://www.vtr1000.org/phpBB3/viewtopic ... nt#p282481

PS: Oil Pressure is a bit misleading. It's fluid ie Brake and Clutch fluid.



(:-})

[VTRPiG]

oops! i did realise that once i had posted it!!!! dumb ass that i am

would this one be a better fit?

http://www.ebay.co.uk/itm/HONDA-CRF450- ... 4ac6b5b1d0

This is all new to me and still getting use to all these wierd and wonderful bits I can get woohoo!

[adyf]

I used that type mate ,worked a treat was goodridge one about 18 quid I think don't forget new copper crush washers or it will piss fluid out now have flat washer type as it worked better and didn't leak about 15 quid .good luck.ady.

[VTRDark]

That will fit. M10x1.25MM

It's a lot more tidy than the old style mechanical switch and you don't have to adjust it. Easy enough to fit too.

(:-})

[Kev L]

I bought a cheapy Chinese one for mine and it leaked like a sieve. Went for Goodridge after that and works a treat.