Need advice on which oil to use or which tyre best suits you? Share your topic and get help here.
tony.mon
Posts: 16286 Joined: Wed Jul 25, 2007 10:46 pm
Location: Norf Kent
Post
by tony.mon » Sun Feb 09, 2014 6:55 pm
Just in case you were wondering:
Now you know where the small and large pipes go to that exit under the petrol tank.
It's not falling off, it's an upgrade opportunity.
agentpineapple
Posts: 15124 Joined: Sat Mar 26, 2011 9:16 pm
Post
by agentpineapple » Sun Feb 09, 2014 7:09 pm
have you been playing with the angle grinder again tony....
HEY YOU GUYS!!!!!!
Jamoi
Posts: 5651 Joined: Sun Jun 30, 2013 2:28 pm
Location: South East England
Post
by Jamoi » Sun Feb 09, 2014 7:30 pm
Did you find the lino vinyl flooring was clogging up your fuel filter?
interesting, I like a bit of plumbing.
Jamie
CruxGNZ
Posts: 77 Joined: Thu Jul 11, 2013 2:40 am
Location: Milwaukee, Wisconsin USA
Post
by CruxGNZ » Sun Feb 09, 2014 8:25 pm
Yes! You rock man. I was just looking for this information.
Since I need to paint my tank anyways, I was going to crack it open and modify it for more capacity. Now that I know what it looks like inside (tubes), I can proceed
sirch345
Site Admin
Posts: 22389 Joined: Mon Aug 25, 2003 10:35 pm
Location: The West Country.
Post
by sirch345 » Mon Feb 10, 2014 9:26 pm
Good one Tony
Chris.
leevtr
Posts: 2105 Joined: Sat Feb 11, 2012 9:16 pm
Location: Romford, Essex
Post
by leevtr » Mon Feb 10, 2014 9:43 pm
The thinner one of the 2 was blocked on my 19 litre tank, causing the bike to cut out every 5 mins. All sorted now though.
" It was 2 minutes 5 minutes ago "
CruxGNZ
Posts: 77 Joined: Thu Jul 11, 2013 2:40 am
Location: Milwaukee, Wisconsin USA
Post
by CruxGNZ » Wed Feb 12, 2014 9:59 am
Tony, do you happen to have a shot a little further away? Or is this all cut up and missing? I was wondering where the metal lines went, from what's shown in the picture untill the bottom of the tank. I'm assuming they just follow the profile of the back of the tank, correct?
tony.mon
Posts: 16286 Joined: Wed Jul 25, 2007 10:46 pm
Location: Norf Kent
Post
by tony.mon » Wed Feb 12, 2014 2:04 pm
Yep, then vertically down to the exits. You can see them in the filler cap; don't use a match to help you see better......
It's not falling off, it's an upgrade opportunity.
CruxGNZ
Posts: 77 Joined: Thu Jul 11, 2013 2:40 am
Location: Milwaukee, Wisconsin USA
Post
by CruxGNZ » Wed Feb 12, 2014 6:56 pm
Thanks!
tony.mon wrote: don't use a match to help you see better......
There's a joke in this somewhere, about peering inside a fuel tank and you guys using the word "torch" for flashlight