Advice re this part. Replace or reuse?

Flatline · Post by **Flatline** » Mon Oct 06, 2014 10:19 pm

Some of the parts in the swing arm have been affected by corrosion

Can they be re-used or not?

Best place to purchase new parts?

Watty · Post by **Watty** » Mon Oct 06, 2014 10:22 pm

I would replace tbh! Looks fairly pitted

AMCQ46 · Post by **AMCQ46** » Mon Oct 06, 2014 10:24 pm

Replace, the surface hardened area is damaged and it will just screw up the replacement bearings

lloydie · Post by **lloydie** » Mon Oct 06, 2014 10:43 pm

Yep replace it as its fecked

Flatline · Post by **Flatline** » Mon Oct 06, 2014 10:57 pm

Best place to buy them?

lloydie · Post by **lloydie** » Mon Oct 06, 2014 11:31 pm

Honda

lloydie · Post by **lloydie** » Mon Oct 06, 2014 11:32 pm

adewhitmarsh · Post by **adewhitmarsh** » Tue Oct 07, 2014 12:26 am

Any good local bearing supply can supply these bearing, just measure them or take numbers stamped on them to the supply.

MacV2 · Post by **MacV2** » Tue Oct 07, 2014 6:31 am

DS or Wemoto or give these guys a go...http://www.cmsnl.com/...or at least compare prices.

VTR1000.ORG