Fitting CCT's

Need advice on which oil to use or which tyre best suits you? Share your topic and get help here.
Post Reply
cotgrave
Posts: 26
Joined: Sat Sep 24, 2016 3:08 pm

Fitting CCT's

Post by cotgrave »

Ok i will be fitting them tomorrow in my living room with the instructions on my tv through the PC.

Never removed carbs before or anything as major as this strip down so wish me luck.

Adrs ccts btw
User avatar
MacV2
Posts: 18018
Joined: Sun Jan 21, 2007 12:07 pm
Location: Grain

Re: Fitting CCT's

Post by MacV2 »

Good luck. Just follow the guide carfully.

If you get stuck with anything...step back, tools down, reveiew, think about it, ask for help if ness. Then continue.
Making up since 2007, sometimes it's true...Honest...
User avatar
bazza696
Posts: 1982
Joined: Mon Aug 10, 2009 12:54 pm
Location: Witham, Essex

Re: Fitting CCT's

Post by bazza696 »

if your in the lounge, don't have the TV on with either the news or Jeremy Kyle, you will get too angry and start breaking things. Play soothing music, but no booze either.
Image
User avatar
Wicky
Posts: 7895
Joined: Sat Feb 11, 2006 2:43 pm
Location: Colchester Essex
Contact:

Re: Fitting CCT's

Post by Wicky »

Good luck - wise move to do it in the warm, and no need to remove carbs... If you do careful with the brittle plastic choke fittings.
It may be that your whole purpose in life is simply to serve as a warning to others.

ImageVTR Firestorm and other bikes t-shirts
User avatar
macdee
Posts: 2351
Joined: Wed Sep 19, 2012 10:35 pm
Location: Portglenone CoAntrim

Re: Fitting CCT's

Post by macdee »

good man giving it a go
the bit that got me was the cams should be facing this way and that way ,it didn't make sense until i actually got stuck in
good luck
told you not to but oh no you knew better
User avatar
alanfjones1411
Posts: 2844
Joined: Thu May 21, 2015 3:33 pm
Location: watford

Re: Fitting CCT's

Post by alanfjones1411 »

When you think you're finished DONT press the starter,turn it over by hand and make sure it turns freely before you press the starter.If it's any consolation i have no mechanical knowledge at all but managed the swap following the excellent step by step instructions on this site.Good luck. :thumbup:
SO WHEN DOES THIS OLD ENOUGH TO KNOW BETTER KICK IN
User avatar
VTRDark
Posts: 20010
Joined: Sun Mar 18, 2012 9:24 pm

Re: Fitting CCT's

Post by VTRDark »

Take your time follow step by step and you will have no issues. If you do that I have every confidence. It has been written in such a way that a layperson can follow it and save you all from doom :thumbup:
==============================Enter the Darkside
User avatar
sirch345
Site Admin
Posts: 22376
Joined: Mon Aug 25, 2003 10:35 pm
Location: The West Country.

Re: Fitting CCT's

Post by sirch345 »

Good luck with it, I hope it's all going well.

If not don't be afraid to ask,

Chris.
Post Reply