Well ..with 103k on her ..time for ground up

[Elchappo76]

And slso ..do you yhink these look like std orig pistons .

Sent from my SM-G900I using Tapatalk

[tony.mon]

Yes, they're standard.

[Elchappo76]

Yes, they're standard.

Ok thank you.

Sent from my SM-G900I using Tapatalk

[Elchappo76]

Yes, they're standard.

Ok thank you.

Sent from my SM-G900I using Tapatalk

Also ..any ideas on why no 3 engraved here.

Sent from my SM-G900I using Tapatalk

[tony.mon]

The bearing codes are written in white paint or engraved on the cases.
Have a look at the Haynes manual for bearing codes and what shells you need.
Same for big ends.

[Big_Jim59]

What a great thread! Thanks for posting. It takes me back to my rebuild. Now I just ride the heck out of it.

[Elchappo76]

Thank you tony. Greatly appreciated.

Sent from my SM-G900I using Tapatalk

[Elchappo76]

Well was just getting it all together to deliver to shop and i noticed this broken tooth on on gear ...can this gear be replaced aww is whole crank gone....

Sent from my SM-G900I using Tapatalk

[Elchappo76]

All good ...

Sent from my SM-G900I using Tapatalk

[Elchappo76]

All good ...

Sent from my SM-G900I using Tapatalk

Is this very common at all tony.

Sent from my SM-G900I using Tapatalk

[tony.mon]

Broken teeth on crank gears?
Never seen one before.

[Elchappo76]

Broken teeth on crank gears?
Never seen one before.

Well tony .. ive been a bit on the waiting side on deciding which way i go on this ..until i just discovered ..a 05 mod engine with 27k on it ..and a constant compression test resulting in a 165 psi . For $500 . So my question now is on installing man ccts .

Sent from my SM-G900I using Tapatalk