I need one, all the breakers are only selling them with the rear axle and I'm not paying £18 for a new one when I have a lathe and can make it from a piece of bar in a few minutes!
I've lost my right hand spacer as well . Looks like the same as narrow front ? I too have nice lathe ,Dean Smith And Grace
I suppose we just make it fit,!! Is the sprocket side different? That's the one I have really lost
You might as well make a set of captive wheel spacers while you're there- it makes it much easier to slip the wheels back in.
Aluminium will do, but they eventually wear at the seal lip. Titanium is better.
It's not falling off, it's an upgrade opportunity.
Made a rear sprocket side top hat type spacer . Get to garage . There it was bottom of parts box dirty and hiding.. Now I need to sort out SA bobbins the under SA support type not good . Creeps forwards then you have no room to manouver rear wheel in . Still now I know . R caliper in first then wheel . All back and just tighten everything up . Green wheels yellow bike .
This could be a serious manic Love affair . Of course lathe turned bobbins
