The damper rod has been ground down and the extra oil relief hole drilled as per the thread below. I've no idea whether they have had the full Roger treatment but this improves the rront end over stock.
https://vtr1000.org/phpBB3/viewtopic.ph ... 79#p280379
The sliders are OK but the stanchions look worn. It's hard to tell in the photos but there are vertical striations where they move through the oil seal. Hardly noticeable to a finger nail but there. The rest of the fork parts are in the bags. Seals look good and the bushes too, made the top ones are worth replacing. No springs but I figure most folks will just swap the internals to their forks.
Not really sure how much to ask. £100 posted? With a set of linear springs these would be a nice upgrade but easy enough to make the mods yourself. More photos if needed
Modified forks SOLD
Moderator: VTRDark
-
freeridenick
- Posts: 1659
- Joined: Fri May 23, 2014 1:30 pm
- Location: Derbyshire
Modified forks SOLD
You do not have the required permissions to view the files attached to this post.
Last edited by freeridenick on Wed Jun 16, 2021 4:05 pm, edited 2 times in total.
Re: Modified forks
A price please Nick, as per forum rules. Thanks in advance,
Chris.
Chris.
Re: Modified forks
Never mind that, I have to know what in the paper isn't just for the cameras?
Is it burning tyres?
Is it burning tyres?
It's not falling off, it's an upgrade opportunity.
-
freeridenick
- Posts: 1659
- Joined: Fri May 23, 2014 1:30 pm
- Location: Derbyshire
Re: Modified forks
Edited Chris
Close. Some crap about Morgan and Reid that's only any good for keeping fork oil off my garage floor.