I've been having problems trying to fit replacement clutch lever (off ebay),it's just a tiny bit non centred.
I'm thinking it's just bad maufacturing rather than me doing anything wrong.
Without the plunger rod in situ it does fit centred but not with the rod in situ.
Any thoughts on this?
The brake lever fitted fine.
I'm hoping adjustable levers will help the clutch action.
replacement levers
Re: replacement levers
Decent leavers cost more for a reason.
If you went for a cheap set then that's the issue.
Over the years & 21 Storms I have never had an issues with a clutch leaver not fitting.
I would make a complaint to the seller if it doesn't fit correctly.
What is the issue with the clutch action?
If you went for a cheap set then that's the issue.
Over the years & 21 Storms I have never had an issues with a clutch leaver not fitting.
I would make a complaint to the seller if it doesn't fit correctly.
What is the issue with the clutch action?
Making up since 2007, sometimes it's true...Honest...
Re: replacement levers
Thanks for reply
They were about 50/60 quid from amazon
The clutch action is hard,ie needs a strong pull, so thought different levers may help.
Friend suggests opening bleed nipple so that the push rod can push in a bit when fitting.
They were about 50/60 quid from amazon
The clutch action is hard,ie needs a strong pull, so thought different levers may help.
Friend suggests opening bleed nipple so that the push rod can push in a bit when fitting.