well the engines in

[warby221]

Well got pi**ed off been of for a week and it’s pi**ed it down

Up side I got pi**ed of with the weather and did my engine swap

Got a nice new engine to run in now went for a shakedown run tonight just had a bit of a leak from one of the hoses of cause sod’s law it had to be one of the buggers under the carb’s so off came the fairing tank and carb’s again to get to it

The motor dose sound sweet though

Just have to put the fairing back on now and its ready to go again
I’ll fire some pic’s on when I get chance
When you change the engine you just about have to strip the bike down all that’s left is the frame, rear sub-frame, front forks and wheel “it did look in a sorry state

[sirch345]

That's good too hear Warby, even better for you I'd imagine after all the effort you've put in, a good feel factor to have it running again

I bet you could smell that paint curing once the engine warmed up

You were lucky the weather stayed bad, as I'm sure if it had been me once the bike was well and truly stripped the sun would come out

Chris.

[sparrowlegs]

Where you out on it yesterday?..think we saw you going down Buncer Lane from the top steep bit avoiding the gravel
Caz xxxx

[warby221]

Yep it was
And he was I thinking I had the stealfiest storm about as no one ever spotted me on it
Got to the old moat house spotted the leak and headed back
Not far for a first run, got 30miles in between showers today though
Engine pulls like a train just a bit of a flat spot at about 3K probably because of the porting work so a bit of rejetting needed at the lower end. Will be having it up to Rogers for a dyno run after its run in so get it all sorted then

[patty]

warby,


pics!!!!!!!!!




pat

[warby221]

oups yer sorry will sort them for 2nite

[patty]

oups yer sorry will sort them for 2nite

good man

pat

[warby221]

Just a couple of pic’s must have had a shaky hand on the camera

Every thing striped off and engine about to come out
Note engine is sat on the floor then the engine bolts are released. The frame is wheeled or wheelbarrow style” not a lot of the bike left”






new engine in with swing-arm and chain on still needing engine cases putting on
note home made abba stand hum £80 I think not

[Beamish]

I am worried Warby. What are you going to do next? You will have to buy a project bike or else you will be bored stupid. Nice work by the way.

[warby221]

I am worried Warby. What are you going to do next?.

Looks like I’ll have to finish all them DIY jobs around the house for the Mrs

Warby, is it going to be done and dusted for the 21st?
:

Bikes up and running tim. Just have to get some more miles on it to run it in only done 30 miles up to now m8

[lloydie]

Just a bump

[AMCQ46]

Strange bump lloydie, but is interesting do me as I have the engine that warby took out

[lloydie]

Yep it was so I could send his profile .
It's not easy to do on iPhone

[sirch345]

I also wondered what was going on when I got the email notification and saw the date this thread was started

Chris.

[Beamish]

I also wondered what was going on when I got the email notification and saw the date this thread was started

Chris.

How are you Chris? Hope all is well doon sarf