Page 6 of 6
Re: vtr. in the beginning....
Posted: Thu Jan 19, 2012 10:38 pm
by rob...
motor out, goes on the bench tomorrow afternoon for some tube-wirling.
note upper front engine mount bolt. LOL.
as i'm either gonna re-use, or sell the frame, i cut thru the engine rather than the frame to keep it's integrety, won't be a prob to make the new engine mounts 2mm longer.
Re: vtr. in the beginning....
Posted: Mon Jan 30, 2012 5:38 pm
by rob...
Re: vtr. in the beginning....
Posted: Mon Jan 30, 2012 5:45 pm
by agentpineapple
bloody hell rob, you changed direction with that......lol
Re: vtr. in the beginning....
Posted: Mon Jan 30, 2012 5:56 pm
by AMCQ46
fooking hell, did you spill beer on your sketch book?
going to have to watch this more closly, cant predict the next move now!
Re: vtr. in the beginning....
Posted: Mon Jan 30, 2012 6:46 pm
by CB_Phil
Nice one, whats gona be the final seating position? Tank gona be up a little higher @ the front?
Re: vtr. in the beginning....
Posted: Mon Jan 30, 2012 8:33 pm
by rob...
tanks will be lower at the font. zx9r fuel pump, i'm trying to emphasize the height of the rear pot. got a seat in mind, we'll see.....
Re: vtr. in the beginning....
Posted: Mon Jan 30, 2012 8:36 pm
by agentpineapple
your not gonna have much ground clearance there dude.....
Re: vtr. in the beginning....
Posted: Mon Jan 30, 2012 8:50 pm
by rob...
4 inches. exactly right for a hard tail.
