Page 1 of 1
Gday from Griffith NSW Australia
Posted: Sat Apr 16, 2011 11:30 pm
by cronky
Purchased a VTR in January, the auto CCT's have been removed and it has manual adjusting ones....Can anyone tell me where to find the adjustment procedure for these ?
Also has a bit of a miss at about 7K. ?
Any help would be much appreciated. Cheers
Re: Gday from Griffith NSW Australia
Posted: Sat Apr 16, 2011 11:49 pm
by tony.mon
Yes, if it squeals it's too tight and if it rattles it's too loose.
And hello!
Re: Gday from Griffith NSW Australia
Posted: Sat Apr 16, 2011 11:51 pm
by lloydie
hello and welcome
Re: Gday from Griffith NSW Australia
Posted: Sun Apr 17, 2011 12:02 am
by benny hedges
cronky wrote:
Also has a bit of a miss at about 7K. ?
ah.
did you fit them yourself?
did you get the bike cheap?
suggest you look in the garage section for the procedure for fitting new tensioners, and re-install yours as if they were new.
just follow it to the letter.
i'll let someone else tell you what the misfire is
Re: Gday from Griffith NSW Australia
Posted: Sun Apr 17, 2011 8:21 pm
by sirch345
G'day from down under cronky and welcome to the forum
I think Benny is suggesting to check the valve timing as it could be 180 degrees out, definitely a possibility I'd say.
Have a look in The Workshop Knowledgebase accessible in the Workshop section.
Chris.
Re: Gday from Griffith NSW Australia
Posted: Sun Apr 17, 2011 9:00 pm
by YETI
hello
from
YETI..
Re: Gday from Griffith NSW Australia
Posted: Sun Apr 17, 2011 10:28 pm
by cronky
Thank you will do some reading.
Re: Gday from Griffith NSW Australia
Posted: Mon Apr 18, 2011 9:34 am
by Leewarne
G day mate,
hope you find the site useful, i know I have
Lee