VTR1000.ORG

I warped my discs racing. So it goes. I am sure you all know that cbr 600 f3 discs fit. I have a wheel and good discs I shall sell soon - I believe this is my 50th post!

I raced my vtr 1000 this year and Jamie's got some of the good bits, but I wish I had made more of an effort to use this site. Must say you have all been most reasonable with my efforts to offload the bits, hopefully this post will get me to 50 so I can answer some messages! I have been singing the ...

43 tooth is 2 extra. Therefore 2/41 roughly 5% over reading of speedo as this reads from front sprocket

also i realised i could put junk posts on to get up to 50 but the moderator correctly removed a post i put up earlier.
so i wanted to behave myself.
i would rather sell the bits to people who are into VTRs.

the silver lever i gave you is much better than the gold one. get the silver one anodised and use the other footpeg and all will be OK. i have a standard set of cams on the way, and i will swap over in near future. i will post pictures of the moriwaki cams to revolution racing to absolutely confirm ...

I list the bits I have left and when I reach 50 put them in the for sale area. this is in case anyone is planning to buy stuff- as i will sell all this to this site before i put it on ebay. i have a set of stage 1 moriwaki cams, a race fairing, race seat unit, race subframe, (all bodywork useable an...

thanks, I still have some bits left but I don't have 50 posts so I cannot reply to personal messages. I have reached 45 or so and I will (assuming all is OK) put the other bits on the sale and wanted section when I reach 50.

although this was made in the 1990s, it is absolutely relevant to today. it's about privatisation of the post office....

Yes I searched my garage for spindles but the only thing I could find we're sv650 engine mounting bolts which were not long enough.

I have a venhill quick action throttle on mine. They supply all you need in the kit to make the cables - but it is not a simple task. Usually you solder the ends on but with stainless steel cables getting solder to stick can be really difficult. You pass the cable through the end hole, splay it a bi...

I decided to put the standard footrests back on my bike and realised you have to take the swing arm spindle out.... A front paddock stand and a rear paddock stand and a jack under the engine. Jack until you can just feel a bit of resistance. That way the bike doesn't cave in when you take the spindl...

i read somewhere that Frank Sinatra's version of My Way was supposed to be the unofficial most requested last song for convicted criminals in the US. In Australia recently the catholic church was getting rather annoyed with contemporary songs being played at funerals and banned all of them. apparent...

if you have friends/relatives who work at a hospital, terrific stuff for bleeding brakes is UNIVERSAL GREEN OXYGEN TUBING as it is viable in diameter - it gets wider then thinner, wider than thinner - so it always fits a nipple tightly. you cut it at the correct diameter point. you connect it to a 6...

NB. don't fully tighten up the banjos etc until you are absouletly sure you have everything in the correct position. if your lines run from the master cylinder and you need to reposition them, you don't want to have tightened down and squashed the copper washers and then find you need to release the...

that sounds typical for chinese stuff, sadly.