Does anyone know which gear cog the speed sensor sits over?
thanks
Speed Sensor
-
Phil-VTwin
- Posts: 348
- Joined: Mon May 11, 2009 11:21 am
- Location: Olney, Bucks
Speed Sensor
Ride Safe
Phil
Phil
Re: Speed Sensor
As far as I know, no-one does.
It's a Japanese-born HRC staff only secret.
Have you tried taking it out, poking a finger in and counting the number of teeth as they go round on tickover?
Time it for exactly a minute and divide by 1200 or whatever your RPM is, then divide that result by Pi which should tell you the number of teeth per revolution.
Then just look it up in Haynes.
Simples!
It's a Japanese-born HRC staff only secret.
Have you tried taking it out, poking a finger in and counting the number of teeth as they go round on tickover?
Time it for exactly a minute and divide by 1200 or whatever your RPM is, then divide that result by Pi which should tell you the number of teeth per revolution.
Then just look it up in Haynes.
Simples!
It's not falling off, it's an upgrade opportunity.
Re: Speed Sensor
I was looking for this answer too but could not find it.
Here is the answer from the Haynes manual:
5th gear on output shaft- 27 teeth
Here is the answer from the Haynes manual:
5th gear on output shaft- 27 teeth
2003 VTR1000 donor bike into an Edge Barracuda