what have you done to your "bike" today

[VTRDark]

I'm mad but not that mad I don't think I have even had the bike up to the redline yet. I have tried but I either run out of road or there is traffic.
It's more than likely fuelling. The bike has always been extra bad on fuel, when I first got the bike it was averaging about 80 ish mpg. Seems to be drinking more since I had the carbs of and set the mixture screws two and half turns out.

(:-})

[AMCQ46]

You know what, I never note how many litres go in at the pump, I always look at the price. When the light comes on I put about £16 in to fill up. Tank has no dents, but I suspect it's fuelling as you said.
The carbs have never been apart in the time I have had it. I have a spare set of carbs, I was going to wait to get a factory pro kit and install that first. But I might just bung them on to make comparisons see how she runs.

(:-})

so that is about 11l for £16, when I have done 100 miles it takes 11l or 12l to fill, but normally the red light is not on yet. so your tank is not dented............bike is running rich, or has a leak

[leevtr]

Fitted new MRA D/B screen. Connected power socket under seat. Got out the tyre pen. Gave her a polish. I think I'm becoming a tart !!

[lloydie]

bike look good but you need a hair cut

[leevtr]

PMSL...Well spotted that man. I didn't even notice that ha ha ha

[agentpineapple]

your mirrors are better than mine, all i ever see is my elbows
lovin the leo's lee
if we go high beach tomorrow, a few people will need ear plugs, your leo's, carl's aratas and my unkown ferkin exhausts, it will be well LOUD!!!!!!!!

[VTRDark]

Today I decided to put my spare set of carbs on the bike. First off I needed to give them a clean. So open up float chamber and this is what I it looked like.






YUK sticky gooey tar like shite everywhere. Look at the state of those jets. So of to Halfrauds and bought some carb cleaning spray. Gave it all a good clean, removed the jets, used a bit of wire alongside the sparay and unblocked the thick yukky like the remains of a bong shite from the jets. Put it all back on the bike and she's running. Done a quick carb sync and adjusted idle speed. Shall see how she runs and what my fuel economy is like.

(:-})

[agentpineapple]

you need to get round mine and do my carbs mate...........
i picked up my dark met grey fairing lowers today from the painter, i'll be fitting them tomorrow along with a fireblade hugger, then it will be just the tank to change and the bodywork will be finished.....YIPPEE!!!!!!!!!!!!
3 pieces of fairing
2x lowers in metalic grey
1x undertray in candy blue
= £120....thats including prep work, i was well pleased with that. i'll try and post some pictures tomorrow....

[lloydie]

I've never seen carbs that bad before
It looks like a smoker

[VTRDark]

Whatever it was it closely resembled nicotine/tar. I bought the carbs on the bay because they looked lovely and clean on the outside and were advertised as coming of a low mileage bike. That must have been one sick bike

BSM, that avatar is very disturbing/distracting and if anyone who has epilepsy is reading through here you might give them a seizure. I will slow the flashing down for you and give you an improved version of it.

(:-})

[agentpineapple]

thats more relaxed, a nice slow fart......

[tankslappa]

Whatever it was it closely resembled nicotine/tar. I bought the carbs on the bay because they looked lovely and clean on the outside and were advertised as coming of a low mileage bike. That must have been one sick bike

Looks like it's been run on a 2 stroke tank mix!

Oh, and by the way... Soldered up the R6 R/R... Looks great...

Only one problem... Damn body work fowls it!

Bl**dy feckin beep beep beep...

So tomorrow I shall be undoing all my nice loom work (yes, it was all taped up), and looking for a better location...

Either that, or cutting the corner off the heatsink...

Guess which one is most likely??

[VTRDark]

heatsink... If it's just the flasher relay in the way, can't you just shift it along the frame a bit.

Looks like it's been run on a 2 stroke tank mix!

More like 60 Capstan navy cuts a day.



(:-})

[agentpineapple]

just remember to mount it in a position where it can get some air flowing over it, having said that, mines in the normal place and with an undertray fitted i doubt it gets much airflow.......doh!!!!!!
i'm making no sense i need to go to sleep......

[tankslappa]

just remember to mount it in a position where it can get some air flowing over it, having said that, mines in the normal place and with an undertray fitted i doubt it gets much airflow.......doh!!!!!!

That's exactly where I was trying to put it, but trying to use one of the original holes and keep clear of the plastic is like a task from the krypton factor!

i'm making no sense i need to go to sleep......

Nah... To easy. I'll leave the low hanging fruit for someone else