heat shrink tubeing

[seb421]

i want to use heat shrink tube on the coils after doing the coil mod, i just need to get a solder before i can finish off

what tube size diameter will i need to join the CBR's to the VTR's i want to run it the full length from the plug at one end to the plug at the other

thanks

also will a hair drier work or will i need a heat gun

[tony.mon]

Halford's do a little box full of various sizes.
Using short lengths will let you slide a larger diameter over a smaller diameter and then heat it, you'll get a better seal form larger to smaller wires that way.
If using a larger diameter sleeve to shrink onto two pieces of wire, squeeze a tiny bit of silicon sealer inside before shrinking it; this keeps water out and the joint can't corrode over time.

[Kev L]

Maplins do packets of heat shrink in 1mtr lengths for reasonable money Seb.

[VTRDark]

Nice tip regarding silicone there Tony.

(:-})

[SMITH MEISTER]

You can also get glue lined heat shrink.

[VTRDark]

WOW that's a new one on me! Nice one SMITH MEISTER.

(:-})