Rh front hanger removal: how?

[Flatline]

Will be changing Tasums front rh hanger

It looks as though the swingarm bolt has to be taken out

So what's the best method?

[Wicky]

You'll need to support the rear end of the bike - hang it from a garage roof / step ladder method

Don't forget to torque the nut back up to spec.

[simo]

The back wheel spindle is the same size so you can push it through pushing s/a spindle out keeping every thing in line.

[AMCQ46]

abba stand on the top rear engine bolt, then remove the swing arm spindle

[VTRDark]

With the swingarm removed it could be the opportunity to renew bearings and grease up the linkages.

(:-})

[tony.mon]

The back wheel spindle is the same size so you can push it through pushing s/a spindle out keeping every thing in line.

Good suggestion, Simo- that's what I do if I haven't got to support the bike from the hoist.
This method works with just a rear paddock stand, no other special tools needed.

Use a chock, though, at the rear of the front wheel, as cup-type paddock stands (as opposed to converted-to-bobbins ones) can "walk" further forward up the SA as you move the bike while working on it.

[Flatline]

Thanks for that

Will sort it out over the next few days