hi level footpeg spacers

[agentpineapple]

as anyone got the specs on the spacer and bolt sizes needed to retain the oem rear footpegs whilst using hi level pipes.
iirc it's a 70mm M8 bolt and a 40mm M8 spacer, can anyone confirm this asap please.

[tony.mon]

Sounds about right, but you can reduce the spacer a little by relieving the footrest casting to allow the pipes to nestle in a bit.
It helps to get a decent "tucked-in" look at the rear.

[Kev L]

Do you want me to measure mine up tomorrow for you?

[agentpineapple]

Do you want me to measure mine up tomorrow for you?

that would be great kev....

[grumpyfrog]

If you find a place to get these, I'm after 2, will even take 4 if you can get your hands on them.
tokens available as usual.

[sirch345]

Rear footrest spacers for my Scorpion cans are:-
50mm long
20mm Outside diameter
10mm Inside diameter

Bolts are M8 X 90mm long taking measurement from underside of socket head,

Chris.

[sirch345]

If you find a place to get these, I'm after 2, will even take 4 if you can get your hands on them.
tokens available as usual.

You could cut this down to the required length (50mm), although if you wanted a polished finish it looks like you would need to do that yourself:-
http://www.ebay.co.uk/itm/ALUMINIUM-ROU ... 5afff24d3c

Chris.

[nt1980]

I still have the high level spacers fitted to mine with the low exhausts i took one off and the spacer is 52 mm long 20mm wide, 8.5 mm hole , m8 bolt 80mm long 25mm thread the rest plain