However when they arrived they were shite and in no way resembled the description, one had a long crack where the pipe meets the can and both had deep pitting on the aluminium where the brackets fit. The pitting couldn't be concealed with the brackets as the marks were wider than the bracket.
There was no way to polish these marks out.
I had considered returning them but really wanted high levels.
After thinking about it at work I wondered if my existing Scorpion stainless cans would fit onto the remus system.
After measuring, it turns out the scorpion silencer jacket will just fit over the remus jackets.
I drilled out the rivets on both sets, cut the baffle tube out of both sets and transplanted the scorpion tubes Into the remus set.
A 10mm strip was cut off the end of the remus cans and fitted back onto the end caps.
The scorpion cans were then slid onto the end caps over the 10mm strips and rivetted on.
.The next problem was the cracks, ground out some of them to clean them out and give somewhere for the filler rod to build up.
Took them to work and tig welded the cracks, then polished up.
Now fitted to the bike with new polished stainless brackets (mounted further up the can to help stop more cracks), they look and sound spot on.
