Link pipe OD measurement

[darkember]

Not being near my bike would anybody know the OD of the link pipe ends for a Scorpion slip-on can system??

[VTR Phoenix]

Would it be the same for other aftermarket slipons? I have the micron pipes sitting here

[Wicky]

Best measure it for your particular system if your sizing it for the replacement clamps - as diameters can differ depending on if gaskets are used or not. I've had to use different sized clamps when either using stock, micron or moriwaki link pipes.

[lloydie]

Normally 52mm

[darkember]

Normally 52mm

Damn was hoping you were going to say 50.9mm. Still at 52mm SP engineering can sort my links to fit their cans. These guys look like they do a really good job and have has some really encouraging reviews.

http://www.spengineering.co.uk/xjr1300-99-03.html

[bigtwinthing]

Mine were 51mm.

[darkember]

Mine were 51mm.

What exhaust system was fitted??

[bigtwinthing]

Mine were 51mm.

What exhaust system was fitted??

Powertech Performance cans and s/s downpipes with Powertech Link pipes.

[darkember]

Mine were 51mm.

What exhaust system was fitted??

Powertech Performance cans and s/s downpipes with Powertech Link pipes.

51 is doable probably actually 50.9 but i do believe the Scorpion systems are 52 just to be awkward so one cannot slip anything else on

[bigtwinthing]

yes you can, on flea bay you can buy a 3" long pipe thats 52mm 1 end and 51 the other. I had some for my Bulldog. £24 posted if i remember correctly.

[darkember]

yes you can, on flea bay you can buy a 3" long pipe thats 52mm 1 end and 51 the other. I had some for my Bulldog. £24 posted if i remember correctly.

Hunt me that down if you can find it

[bigtwinthing]

i will have a look this w end.